WatchNet RTS series Bedienungsanleitung PDF herunterladen (Seite 4)

Zone Status Messages

The table below describes the typical commands used to query the control panel for a Zone Status and the

zone’s partition. NOTE: The system can provide the status for zones 1 to 96 only.

Zone Status Request and Report Messages

Action String Definition

Zone Status

Request

08zs004B (CR-LF) The panel responds with a Zone Status Report.

Note: This message should be sent only when an initial

connection is made with the panel. It is not intended for use

as a ‘polling’ command. The panel can be programmed to send

System Notification Messages concerning zone status.

Zone Status

Report

68ZSD…00CC (CR-LF) The panel sends this message in response to a Zone Status

Request. The data portion of this message is 96 characters

(one character for each zone in order). Each character is the

sum of all applicable status values, expressed in hexadecimal

using ASCII characters 0-9 and A-F.

Status Values

0 Closed

1 Open

2 Trouble

4 Alarm

8 Bypassed

Example: a Zone Status Report for a system in which Zone 1

is Open, Zone 2 is Open, in Trouble, and Bypassed, and the

rest Closed, would begin 68ZS1B00…

Zone

Partition

Request

08zp0004E (CR-LF) The control panel responds with a Zone Partition Report.

Zone

Partition

Report

68ZPD…00CC (CR-LF) The panel sends this message in response to a Zone Partition

Request. The data portion of this message is 96 characters

long, one character for each zone in order. The value will be

from 0-8, with 0 meaning no partition assignment.

Example: a Zone Partition Report for a system in which Zone

1 is assigned to Partition 2. Zone 2 is assigned to no partition,

and Zone 3 is assigned to Partition 8, would begin68ZP208…

1 2 3 4 5 6 7 8 9 10

Keine Kommentare

WatchNet RTS series Bedienungsanleitung Seite 4